Roller Clean Max

In the sump of the Maxspect Lagoon aquarium, water flows in by gravity and then passes through the filter fabric of the ROLLER CLEAN MAX, which removes impurities. Over time, the filter fabric becomes clogged with dirt particles, reducing its filtration capacity. As a result, the water level rises in the receptacle until it activates the level sensor, which instructs the controller to rotate the motorized drum. This drum winds up the dirty filter fabric, placing a new clean section under the water flow. After this operation, the water level drops again, and the motorized drum automatically stops. This cycle will continue until there is no more filter fabric on the roll, at which point it will need to be replaced.

Simple!
Replacing the filter fabric roll is easy: simply remove the cassette from the support of the Maxspect Lagoon aquarium, take out the dirty filter roll from the cassette, replace it with a clean roll, and put everything back into the sump.

The window! 
By opening the lower window on the left side of the support cassette, part of the water will not pass through the filter fleece anymore. This setting is very important, because after a certain period of use of the ROLLER CLEAN MAX, the water could become too poor in nutrients and in this case, not all the water must pass through the filter fleece.
 
In colour!
The controller is fitted with 3 different colour LEDs which, when lit, give the following information:
 

• Green LED : the controller has initiated the rewinding by the motor drum of the filter fleece,
• Blue LED : the level sensor is blocked, the controller has detected that the level sensor has been activated too long during the rewinding of the fleece,
• Red LED : The drum motor is blocked ; the controller analyses the power of the motor during its operation and stops it if it is overloaded.

The ROLLER CLEAN MAX filter fleece.
The density and structure of the ROLLER CLEAN MAX filter fleece are specially designed for use in freshwater and saltwater aquariums.
 
Therefore, the ROLLER CLEAN filter fleece allows the removal of the largest waste particles which can be a source of excess of nitrates and high phosphates, but doesn't completely eliminate the nitrogen and phosphorus components. The filter fleece also doesn't remove salts and trace elements from the water, thus ensuring stable aquarium water parameters.
 
The structure and the density of the ROLLER CLEAN MAX filtering fleece allow a much more important water flow compared to certain similar products. They also ensure a faster drying of the fleece after the filtration process.
 
The filtering fleece ROLLER CLEAN MAX doesn't affect the correct performance of the protein skimmers.
 
The ROLLER CLEAN MAX filter fleece has received a positive approval from the National Research Institute of Animal Production in Poland, which is the result of more than three years of detailed research in experimental freshwater and saltwater aquariums.
 
Additional information!
The mounting brackets supplied with the ROLLER CLEAN MAX allow for installation in the designated location for sump filters.

A roll of filter fleece lasts from 1.5 to 3 months, depending on the settings and contamination of the aquarium.
The standard length of a roll is about 42 m, the maximum flow rate through the filter fleece is 8000l/h.
Dimensions: 29 x 13 x 41 cm.
No connections are required.
Complete water filter unit ready for use - no assembly!